10
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
ASSEMBLY
PREPARATION
•
Make sure that all parts are un-damaged and are present. If any parts are
missing or damaged please contact your CLARKE dealer immediately.
•
For maximum stability, the bandsaw should be bolted to either a
workbench, a suitable stand, or a piece of plywood, and the plywood
then clamped firmly to a workbench using clamps, while the bandsaw is
being used.
•
The saw must be located in an area large enough to allow you to work
freely, taking into account the size of your workpiece and that there is
adequate lighting.
•
Make sure that the electrical supply is close by. Take extra care if extension
leads are used. Make sure that there is no possibility of tripping over the
lead when moving around the work area.
FITTING THE TABLE
1. Fit the work table to the bandsaw
using the table locking lever
components.
2. Screw the locking knob and
washer finger tight to the frame to
secure the table.
3. Add the locking lever and its
retaining bolt to the locking knob,
tightening the retaining bolt
gently with the hex wrench.
4. Check that the table can still move when the locking lever is loosened.
5. Ensure the saw blade is central in the table insert.
