6
MAINTENANCE
Daily
1. Before use, drain water from air tank, air line and compressor.
2. If no line Lubricator is used, ensure that oil is applied to the tool (see below).
Weekly
Clean the air inlet filter screen (within parts list item 31).
Monthly
Oil the Hammer mechanism at least once per month, by removing the hex. socket
screw in the side of the tool, and injecting a few drops of oil, (SAE30).
For lubricating the air motor, an air line lubricator should be used, with Clarke Air Line
Oil, adjusted to 2 drops per minute. If this is not possible, run a few drops of oil through
the tool. It may be entered into the tool air inlet, (ensuring the strainer is clear), or into
the hose at the nearest connection to the air supply. Then run the tool.
Clarke Air Line Oil is available from your CLARKE dealer, part no. 3050825.
Be aware that factors other than the tool may effect its operation and efficiency,
such as reduced compressor output, excessive drain on the airline, moisture or
restrictions in the line, or the use of connectors of improper size or poor condition
which will reduce air supply.
Grit or gum deposits in the tool may also reduce efficiency. This condition can be corrected
by cleaning the air strainer and flushing out the tool with gum solvent oil, or failing this, the
tool should be disassembled, thoroughly cleaned, dried and reassembled.
If the tool runs erratically or becomes inefficient, and the air supply is sound,
dismantle the air motor and hammer mechanism and replace worn or damaged
parts, or take the tool to your CLARKE dealer.
Keep the tool clean at all times, and ensure that the hex. socket screws securing
the hammer case remain tight.
SPARE PARTS AND SERVICING
Contact your nearest dealer, or CLARKE International, on one of the following numbers.
PARTS & SERVICE -
020 8988 7400
PARTS & SERVICE E-Mail: Parts(or Service)@clarkeinternational.com
ACCESSORIES
A wide range of Airline accessories is available, including Filter/Regulators,
Lubricators, High Pressure Hoses from 5 to 100 Metres, etc.
Contact your CLARKE dealer for further information, or CLARKE International
Spare Parts Department on 020 8988 7400
DISPOSAL
When disposing of this product, ensure it is disposed of according to all l.ocal
ordinances
