7
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
BEFORE USE
NOTE:
Ensure the compressor is turned off.
1. Remove the plastic blanking plug from the air inlet connection.
2. Pour 2-3 drops of CLARKE airline oil into the inlet port. This should be done
regardless of whether or not a lubricated air supply is to be used.
3. If the air supply is unlubricated, an in-line mini oiler be added to the air tool.
• A mini oiler helps to prolong the life of any air tool.
4. If a mini-oiler is not being used, run a few drops of oil through the tool
before use. It can be entered through the airline connector or via the hose
at the nearest connection to the air supply.
5. Connect a suitable hose as shown
or use the inlet adaptor supplied to
connect directly to the hose.
6. Connect the other end of the hose
to the compressor.
7. Turn on the air supply and check
for air leaks. Rectify any found
before proceeding.
• PTFE tape may be useful for
sealing threaded connections.
8. If using a mini oiler, place a sheet of paper next the exhaust port and hold
the throttle open for approximately 30 seconds. The oil volume is correctly
set when a light stain of oil can be seen on the paper. Excessive oil should
be avoided.
Your impact wrench is now ready for use.
You can fit a whip hose with a quick fit coupling if required, available from
your CLARKE dealer.
Summary of Contents for CAT179
Page 16: ......