2
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
ASSEMBLY
SPECIFICATIONS
1. Make up the front frame by connecting the
two legs, a long spreader bar, and the long
shelf support as shown, Fix them together
using the bolts, nuts and spring washers.
• The nut and spring washer should be on the
inside of the completed frame
• Do not fully tighten the nuts and bolts at this
stage.
2. Make up the rear frame in the same way.
3. Join the two frames using the two short shelf
supports and two short spreader bars, again
fixing them together using the bolts, nuts and
spring washers.
• The short spreader bars should be place on
the inside of the frame.
4. Place the two shelves into position.
5. Fit the feet to the end of each leg.
6. Place the the top panels on to the short
spreader bars as shown, set to the required
distance apart and fix in position using the
screws and washers supplied.
• The screws are inserted from below through
the short spreader bars into the top panels.
7. Tighten up all the nuts, bolts and screws. The tool
stand is now ready for use.
Model Number
CAMTS
Maximum Load
226 kg
Weight (unpacked)
11.5 kg
Dimensions (L x W x H)
810 mm x 570 mm x 810 mm
