12
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
FITTING AND REMOVING A DISC
1. Make sure the correct disc guard is fitted before you fit any cutting/
grinding disc.
2. Press and hold the spindle lock as
shown on the right.
NOTE:
You may need to turn the
spindle by hand to fully
engage the spindle lock.
3. Use the pin spanner supplied to
remove the outer flange.
4. Make sure that the inner flange is
fitted correctly with the raised
circular section pointing outwards
as shown and the flat section on the opposite side engages with the flat
section on the spindle.
5. Place the grinding disc over the
spindle and on top of the inner
flange.
• Place the disc onto the spindle
as shown.
• Make sure that the disc is
properly located on the inner
flange.
6. Place the outer flange over the
spindle.
• For standard discs make sure that the raised section of the outer
flange is pointing towards the disc.
• When using thin discs, the outer flange washer can be reversed so
that the raised section is pointing away from the disc.
7. Press and hold the spindle lock and use the pin spanner to tighten the
outer flange.
WARNING: MAKE SURE THAT THE ANGLE GRINDER IS SWITCHED OFF AND
UNPLUGGED FROM THE MAINS SUPPLY BEFORE FITTING OR REMOVING
ANY ACCESSORIES.
