OPERATION
IMPORTANT
: DO NOT plug the tool in to the mains, unless you have ensured it is
switched OFF and the guard is set to the desired position.
The hand holding the body will control the ON/OFF switch, whilst the other hand
grasps the hand grip and guides the tool over the workpiece.
Hold the tool firmly but not tightly. Allow the tool to do the work...DO NOT force the
wheel on to the workpiece.
MAINTENANCE
IMPORTANT: Before carrying out any maintenance tasks, ALWAYS disconnect the
tool from the mains electrical supply.
Before Each Use
1.
Always inspect the tool before use, and ensure it is in top condition.
2.
Ensure all air vents are clear, use compressed air to clean the tool where
possible. (Always wear protective goggles when cleaning with compressed
air).
3.
Check the power cable to ensure it is sound and free from cracks, bare wires
etc.
4.
Ensure the grinding wheel or cutting disc is perfectly sound, free from cracks
or damage in any way.
After every 50 hours of use.
Unscrew Carbon Brush Caps, withdraw the Carbon
Brushes and check their condition. They must be replaced
when they have worn down to 6mm in length. If they are
found to be serviceable, blow the brush holder clean
with compressed air, and replace.
SPECIFICATIONS
Motor ........................................................... 230V~ 50Hz 1ph
Power Rating ............................................... 720Watts
Fuse Rating .................................................. 13Amps
No Load Speed .......................................... 11,000RPM
Wheel/Disc Dia. .......................................... 115mm
Bore .............................................................. 22mm
Weight (Net) ................................................ 2.3kg
Part No. ........................................................ 6470130
7
