10
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
SETTING THE WORK SUPPORTS
1. Loosen the work support locking
screws.
2. With the saw upside down, slide
the work support guide rods
through the holes in the base of
the saw and secure with the
spring clips.
3. Set the saw upright.
4. Extend the work supports as
required and secure them in
place using the work support
locking screw.
5. The work support incorporates a
hinged end stop which can be
raised if required.
FITTING THE WORK CLAMP
1. Loosen the clamp support
thumbscrews.
2. Slide the work clamp post into one
of the clamp supports on either
side of the saw and tighten the
thumbscrew to lock it in place.
NOTE:
When swivelling the saw to
one side the motor may
strike the clamp post.
3. Adjust the clamp to suit the
workpiece.
4. Tighten the upper thumbscrew to secure the work clamp.
Summary of Contents for C2MS210MP
Page 24: ......
