14
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
OPERATION - GENERATOR
IMPORTANT: Ensure all precautions are taken, referring to this and the
engine manual, before proceeding.
1. Start the engine. (refer to engine manual) and allow to run for a few
minutes at full speed in order for it to warm up.
IMPORTANT: Ensure no appliances are connected to the generator when
starting the engine.
2. Check the condition of the appliance, including the supply cable and the
extension cable if used, and ensure it is switched OFF. Ensure also that the
operating voltage is the same as the output from the generator.
3. Ensure the voltage selector switch, shown at ‘C’ Fig.2 is set to the deliver
the appropriate output - 115V or 230V.
4.
Turn the Gen/Weld knob -
A’ Fig1, to
GEN.
5. T
urn the Welding Current
knob - ‘B’ Fig.1, to
GEN
230V.
6. With the engine running
smoothly, connect the
appliance to the
appropriate receptacle:
BLUE - 230V, YELLOW - 115V.
7. Switch ON the appliance.
NOTE: If the AC circuit is overloaded the
circuit protection switch will trip. To reset the
circuit, first disconnect the appliance, and
rectify the cause of the overload. Wait a short
period and then press the appropriate reset
button, shown at ‘A’ and ‘B’, Fig.2.
BE AWARE!
Some appliances draw more current on start-
up than their normal running current, i.e.
electric motors and compressors. If in any
doubt as to whether an appliance is
compatible or not, please consult your
CLARKE dealer.
Additionally, please refer to the specifications to ensure the machine is used
under the correct operating conditions.
Summary of Contents for 8130535
Page 24: ......
