4
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
BEFORE USE
UNPACKING AND ASSEMBLY
1. Remove the retaining clip by
pressing the yoke downwards and
pulling the clip away.
• The yoke can now hinge up
and down freely.
2. Insert the jack handle into the
handle socket.
• The handle will engage with
the jack control valve at the
base of the yoke.
3. Tighten the retaining bolt if
required to retain the handle in
the jack.
4. Add the upper handle by sliding it
onto the lower handle until the
spring loaded pin clips into place.
PURGING AIR FROM THE SYSTEM
If air bubbles become trapped inside
the hydraulic system during shipping
or transport, the efficiency of the jack
will be reduced and the jack will feel
spongy.
1. Turn the control handle counter-clockwise, relieving the pressure inside the
jack.
2. Pump the handle several times to purge air from the system.
3. Turn the control handle clockwise and test the jack. If efficiency is still poor,
check the oil level as described under Maintenance on p7.
The jack is now ready to use.
Summary of Contents for 7623250
Page 12: ......
