3
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
SAFETY PRECAUTIONS
1. Only trained persons should operate this lifting equipment.
2. ALWAYS ensure that sufficient light is provided and that the work area is
kept clear of unrelated items.
3. ALWAYS inspect the jack before use. Make sure that all parts are in good
condition and operating smoothly and that no cracks or distortion is
apparent. If in doubt do not use. Have the damaged parts replaced or
consult your CLARKE dealer.
4. The jack must be maintained and repaired by suitably qualified persons.
5. DO NOT make any modifications to this jack or adjust any valves.
6. DO NOT use the jack if an oil leak is apparent. Consult your CLARKE dealer.
7. DO NOT try to lift more than the 3 Tonne rated load for the jack.
8. This jack is for lifting only; do not move a load using the jack as a dolly.
9. DO NOT use to lift people and that no-one is in the vehicle during lifting.
10.
Make sure that the jack is on a firm level base and there is no possibility of
it slipping when under load
.
11. Only use the jack on solid ground, preferably concrete. Avoid
tarmacadam as the jack could sink in.
12. Make sure the load is taken by the full saddle and that the point of lift on
the load is strong enough to support the load adequately.
13. DO NOT work under the raised vehicle until it is supported by suitable
means e.g. axle stands. NEVER rely on the jack to support the vehicle by
itself.
14. NEVER push a load off the jack.
15. Ensure that all personnel are well clear of a load being raised or lowered.
16. Consult the vehicle handbook to determine the correct lifting points.
17. It is necessary that the operator watch both the jack and the load during
operation.
18. Check the condition of the labels regularly and replace if required.
WARNING: THE OPERATOR MUST FOLLOW ALL INSTRUCTIONS WITHIN THIS
INSTRUCTION BOOKLET
Summary of Contents for 7623250
Page 12: ......
