24
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
TROUBLESHOOTING
If the following does not solve your problem, please contact the CLARKE service
department.
PROBLEM
CAUSE
SOLUTION
Engine will not
start, see
engine manual
for further
engine
troubleshooting
No fuel
Add fuel (See Page 12)
Low oil
Add oil (See Page 11-12)
Pressure builds up
after two pulls on the
recoil starter or after
initial use
Squeeze the gun trigger to relieve
the pressure
Spark plug wire not
attached correctly
Attach the spark plug wire
Engine switch is in the
OFF position
Set the engine switch to the ON
position
Choke lever is set to
the choke position
when the engine is
warm
Set the choke lever to the RUN
position (See Pages 14)
Fuel valve closed
Open the fuel valve
Lack of
pressure (initial
use) continued
Throttle control lever is
not in the fast position
Move the throttle control lever to the
fast position
Choke lever is in the
CHOKE position
Move the choke lever to the RUN
position (See Pages 14)
High pressure hose is
too long
Make sure the high pressure hose is
under 100 feet
No or low
pressure (after
a period of
normal use)
Worn seal
Have it replaced by your dealer
Worn or obstructed
valves
Have it replaced by your dealer
Worn unloader piston
Have it replaced by your dealer
Worn E-Z start valve
Have it replaced by your dealer
Summary of Contents for 7330375
Page 32: ......