9
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
CONNECTING THE WATER SUPPLY
Always follow the regulations of your local water supplier. The pressure washer
must never be connected to the drinking water supply without using a system
separator (also known as a backflow preventer) available from most
hardware stores.
NOTE:
Water that has flowed through a system separator is considered non-
drinkable.
1. Connect a water supply hose (not
supplied) to the water inlet.
• Make sure that the water filter is
installed behind the hose
connector on the water inlet
NOTE:
Use a good quality fibre-
reinforced water hose with a
standard coupling.
NOTE:
This machine has the ability to
draw its own water, meaning
you can use water not under pressure such as rainwater collected in a
water butt. See page 16.
BEFORE USE
IMPORTANT: The engine is supplied without any oil in it and must be filled to
the correct level before use, see below.
ENGINE OIL
1. Turn the oil filler cap anticlockwise
and remove it from the engine,
wipe the integral dipstick with a
clean cloth.
WARNING: STAND THE PRESSURE WASHER ON LEVEL GROUND WITH THE
ENGINE SWITCHED OFF.
WARNING: TAKE CARE NOT TO TOUCH ANY HOT PARTS OF THE PRESSURE
WASHER WHEN CHECKING THE OIL LEVEL.
Summary of Contents for 7320212
Page 28: ......
