13
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
INTERRUPTING OPERATION
1. Release the trigger.
NOTE:
The pressure washer will automatically go into bypass mode.
NOTE:
If you notice water coming from the drain tube attached to the pump,
please note that this is a safety feature and should be expected, it
cools the pump by releasing some of the hot water within the pump
and replacing it with fresh ‘cool’ water.
2. Rotate the trigger lock to the
locked position.
ADJUSTING THE SPRAY NOZZLE
The nozzle is adjustable to allow you to adjust the water delivery from a narrow
jet of water to a wide spray. To adjust the nozzle, proceed as follows:
1. Hold the shaft of the lance in one
hand.
2. Twist the nozzle with the other
hand.
3. The spray varies between narrow
and wide as you turn the nozzle.
• The narrow jet should be used to clean small areas where a small
spray is required.
• The wide spray should be used for cleaning large areas.
ADJUSTING THE PRESSURE
Hold the rear of the nozzle and slide the front of the nozzle forwards to low
pressure and backwards for high pressure.
Other ways to adjust the pressure include. Changing the distance you are
from the surface being cleaned and adjusting the spray to a wider angle
(lowers the pressure).
WARNING: DO NOT ALLOW THE UNIT TO OPERATE IN BYPASS MODE FOR
MORE THEN TWO MINUTES AT ANY TIME. TURN THE UNIT OFF IF IT IS NOT
GOING TO BE USED FOR A PERIOD LONGER THAN THIS. SEE PAGE 14.
Summary of Contents for 7320201
Page 28: ......