12
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
PREPARING FOR USE
INSTALLING CHISEL AND BIT
CAUTION: THE CHISEL AND DRILL BIT ARE EXTREMELY SHARP...TAKE CARE WHEN
HANDLING!
1. Open the cover at either side of
the head, by unscrewing the single
securing screw then pulling down
on the plastic catch to expose the
chuck.
2. Insert the drill bit into the chisel
then insert the chisel and bit up
through the hole in the head.
3. Push the chisel up as far as possible
into the head and nip up the grub
screw to temporarily hold it in this
position, using the hex. wrench
provided.
4. You can lower the drill bit gently
and allow it to rest on the table
whilst carrying out this operation.
NOTE:
The opening in the side of the
chisel should always be to the
right or left, never to the front or rear. The openingallows chips to
escape duringoperation. See ‘Adjusting Chisel Parallel to
Workpiece’ on page 14.
WARNING: MAKE SURE THE MACHINE IS DISCONNECTED FROM THE
MAINS SUPPLY BEFORE PERFORMING CHECKS, ADJUSTMENTS, OR SETUP
PROCEDURES.
Summary of Contents for 6500015
Page 24: ......
