6
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
HOW TO CHARGE THE BATTERY
NOTE:
New batteries must be charged before use.
1. Connect the battery charger to the power supply.
2. Remove the plastic clip that covers the battery terminals.
3. Slide the battery charger clip into
the battery as shown.
• Charging takes approximately
90 minutes.
4. Remove the charger clip from the
battery and replace the plastic
clip.
5. Disconnect the charger from the
power supply.
FITTING THE BATTERY PACK
TO FIT THE BATTERY
1. Remove the plastic clip that
covers the battery terminals.
2. Slide the battery pack into the
stapler/nailer until it clicks into
place.
TO REMOVE THE BATTERY
1. Press and hold the release buttons
on either side of the battery.
2. Slide the battery pack out of the
stapler/nailer.
3. Place the supplied plastic clip
over the battery terminals.
WARNING: THE BATTERY CAN BE WARM TO THE TOUCH WHEN REMOVED
FROM THE TOOL. ALWAYS LET THE BATTERY COOL DOWN BEFORE
RECHARGING. DO NOT RECHARGE A WARM BATTERY.
Summary of Contents for 6487057
Page 12: ......