11
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
USING THE DRILL
BEFORE STARTING WORK
1. Before drilling into walls and floors etc., check first that there are no hidden
electrical cables, gas or water pipes etc.
2. Check the mains voltage before plugging in and switching on.
3. Ensure the work area is as hazard free as possible.
STARTING WORK
1. Select and install the bit to be used. See page 8.
2. If required, adjust the support handle attachment for the most comfortable
position. See page 9.
• For safety, always use the hammer drill with the front handle attached.
3. Set the required operating mode. See page 9.
4. When drilling vertically overhead,
fit the rubber dust shield cup
shown onto the drill bit.
5. Position the tool against the
surface to be drilled and pull the
trigger switch.
• If using the hammer action do
not start the drill until the tool is
in contact with the work
surface.
STOPPING WORK
1. Release the trigger and wait until the bit has stopped before placing the
drill on any surface
Summary of Contents for 6479600
Page 20: ......
