9
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
1. Clean and grease the chisel
shank. DO NOT lubricate the
machine.
2. Pull out and rotate the stop lever
180 degrees clockwise
3. Insert chisel into the chuck clamp
with the flat face of the chisel
facing the stop lever.
4. Pull out and rotate the stop lever
180 degrees anticlockwise to lock
the chisel in place.
5. Check by pulling the chisel to see if it is locked in place.
NOTE:
Be aware that the hammer action requires the chisel to be able to
move axially by 2-3 cm.
6. To remove the chisel, reverse the above steps.
7. DO NOT allow dust or debris inside the chuck as this will cause problems in
the future
USING THE HAMMER
WARNING: ALWAYS CHECK OIL LEVEL BEFORE USE - SEE PAGE 8
BEFORE STARTING WORK
1. Before hammering into walls and floors etc., check first that there are no
hidden electrical cables, gas or water pipes etc.
2. Check the mains voltage (230v~50Hz) before plugging in and switching on.
3. Ensure the work area is as hazard free as possible.
STARTING WORK
1. Select and install the chisel to be used. See page 8.
2. If required, adjust the auxiliary handle for the most comfortable position,
see page 8.
• For safety, always use the hammer with the auxiliary handle attached.
CAUTION: WHEN REMOVING A BIT FROM THE HAMMER, REMEMBER THAT
IT MAY BE EXTREMELY HOT. EITHER ALLOW IT TO COOL DOWN FIRST OR
USE INDUSTRIAL GLOVES TO REMOVE THE BIT.
Summary of Contents for 6479509
Page 16: ......
