9
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
To fit a collet, proceed as follows.
1. Press and hold down the spindle
lock.
•
It may be necessary to rotate the
chuck to fully engage the spindle
lock.
2. Remove the chuck by rotating the
chuck sleeve in an anti-clockwise
direction.
•
A spanner is supplied for this
purpose.
3. Pull the collet out of the spindle.
4. Insert the collet required, pushing it
into the spindle as far as it will go.
5. Refit the chuck, pressing the
spindle lock to tighten it.
FITTING AN ACCESSORY TO THE TOOL
IMPORTANT: Ensure the tool is switched OFF
TO FIT AN ACCESSORY PROCEED AS FOLLOWS.
1. Make sure that the correct size collet has been fitted.
2. Press and hold down the spindle
lock.
3. It may be necessary to rotate the
chuck to engage the spindle lock.
4. Rotate the chuck sleeve in an
anticlockwise direction until the
collet jaws are open sufficiently to
accept the accessory.
Summary of Contents for 6462000
Page 16: ......