13
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
CLEANING AND MAINTENANCE
1. ALWAYS unplug the tool from the mains supply and ensure it is switched OFF
when performing maintenance tasks.
2. The tool should be kept clean at all times. Ensure the ventilation ducts are
clear and the power cable is in good condition. Get into the habit of
cleaning thoroughly after each use and before storing.
3. After use, thoroughly clean all chippings and dust from the rotary tool,
taking special care to clean the cooling vents.
4. Never clean with solvents. Use a moist cloth with soapy water if necessary.
5. Clean the spindle lock, the chuck and the spindle collar.
6. Keep all accessories sharp and clean.
The tool incorporates sealed for life bearings and does not require lubrication.
There are no user serviceable parts inside this tool.
Worn or damaged parts should be replaced by qualified personnel.
Refer to qualified service personnel if internal maintenance is required.
ACCESSORIES
Accessory Kits are available from your dealer. Please quote part number
6468025 (CRT100A - 100 piece) or part no 6462001 (CRT40 - 40 piece kit).
ENVIRONMENTAL RECYCLING POLICY
By purchasing this product, the customer is taking on the obligation to
deal with its safe disposal in accordance with the Waste Electrical and
Electronic Equipment (WEEE).
This product must not be disposed of with general household waste but be
disposed of according to the laws governing Waste Electrical and Electronic
Equipment (WEEE) at a recognised disposal facility.
This product contains valuable raw materials. Metal products should be taken
to your local civic amenity site for recycling.
WARNING: MAKE SURE THAT THE TOOL HAS BEEN DISCONNECTED FROM
THE POWER SUPPLY BEFORE REMOVING OR FITTING A COLLET OR
ACCESSORY
Summary of Contents for 6462000
Page 16: ......
