10
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
THAWING WATER PIPES
Fit the reflector nozzle to the front of the hot air gun.
1. Always heat frozen areas inwards from the edge to the centre.
2. Take special care when defrosting plastic pipes.
3. Provide protection against heat damage to nearby paint and wall
coverings where necessary.
4. Be aware that copper gas pipes can be difficult to distinguish from copper
water pipes. Always check first.
5. Copper pipes are soldered together, therefore should not be heated
above 200
o
C.
MAINTENANCE
This hot air gun is maintenance free, except always ensure that the air intake
vents are kept clean. If used in a dusty environment clean the tool with low
pressure compressed air.
DECLARATION OF CONFORMITY
Summary of Contents for 3400764
Page 12: ......
