8
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
FITTING THE HANDLE
The drill is supplied with an auxiliary
handle. To install it proceed as follows.
1. Slide the clamping ring over the
body of the drill, ensuring it rests
against the flat shoulder shown.
2. Twist the handle to tighten the
clamping ring around the drill
body.
• The handle can be rotated to
any position around the drill by
loosening the handle and adjusting its position.
INSERTING/REMOVING THE DRILL BIT
1. Open the chuck jaws by gripping
the lower part of the chuck and
turning the upper part counter-
clockwise by hand.
• The direction of twist is
embossed on the upper chuck
body.
2. Place the drill bit in the jaws of the
chuck as far as it will go.
3. Close the chuck jaws and tighten
to grip the drill bit by turning the upper chuck clockwise by hand while
holding the lower part.
4. Make sure that the chuck jaws are fully closed and that the drill bit is held
firmly.
5. Your drill is now ready for use.
Summary of Contents for 3120172
Page 16: ......
