Clarke 3110863, Operation & Maintenance Instructions Manual

Page: 13 / 16

13
MAINTENANCE
WARNING! Make sure that the air drill is disconnected from the air supply before
starting any cleaning, or maintenance procedures.
DAILY BEFORE USE.
1. Drain water from air tank, air line and compressor.
2. Check and clean the air inlet gauze filter if necessary.
3. Pour a few drops of CLARKE Air Line Oil, into the air inlet. This should be carried out
regardless of whether or not an air line lubricator is used. If an Air line lubricator is not
used, this procedure should be repeated after every two to three hours of use.
CLEANING
• Keep the body of the air drill clean and free from debris, Grit or gum deposits in
the tool may reduce efficiency.
SERVICE AND REPAIR
• All servicing and repair must be carried out by qualified service technicians.
NOTES
Be aware that factors other than the tool may effect its operation and efficiency such as
reduced compressor output, excessive drain on the airline, moisture or restrictions in the
line, or the use of connectors of improper size or poor condition which will reduce air
supply.
**Clarke Air Line Oil is available from your CLARKE dealer part no. 3050825.