9
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
REMOVING TOOLS FROM THE AIR HOSE
1. Push down on the On/Off button
to stop the compressor.
2. Set the pressure regulator to the
lowest setting (fully anticlockwise).
3. Activate the tool (spray gun etc)
to depressurise the air hose.
4. The tool can then be
disconnected from the hose.
SHUTTING DOWN THE COMPRESSOR
1. Follow steps 1-3 in “Removing Tools
From The Air Hose” above.
2. Disconnect the compressor from
the mains supply.
• Never leave the compressor
unattended while the tank is
pressurised.
• Always release the pressure
from the tank when not in use or
prior to storage, as described in
the following section.
WARNING: ALWAYS SET THE PRESSURE REGULATOR TO ZERO BEFORE
ATTEMPTING TO REMOVE OR REPLACE A TOOL.
Summary of Contents for 2322020
Page 20: ......
