13
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
RESET BUTTON
This compressor has a thermal
overload device.
If the motor gets too hot, the thermal
overload device cuts the power
which prevents damage to the motor.
If the thermal overload device
operates, let the motor cool down for
5 minutes and push the reset button.
If you start the compressor and the
overload cutout operates again, stop
the compressor and disconnect from the power supply and have your
compressor examined by a qualified service agent.
MAINTENANCE
CAUTION: ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE CARRYING
OUT ANY MANTENANCE
DRAINING THE RESERVOIR
After use, always open the drain valve to make sure that any condensate is
drained off.
CLEANING THE AIR FILTER
The air filter should be examined occasionally in dusty conditions,
1. Unscrew the plastic shroud from
the compressor to expose the
working components.
2. Clean the sponge filter using a
soft brush. If necessary, the filter
can be carefully cleaned in warm
soapy water.
• Rinse and let the filter dry
completely before refitting.
3. Refit the filter assembly before
use.
• If the filter is damaged it must be replaced.
4. Refit the plastic shroud. This should always be fitted before reconnecting
and starting the compressor.
Summary of Contents for 2242035
Page 20: ......
