Clark WSTX33, Operator'S Manual

Page: 42 / 80

4-4
Section 4. Operator Maintenance and Care
Functional Checks
Check the operation of the truck as follows:
NOTICE
Before performing these checks, familiarize yourself
with the operating procedures in Section 5.
1. Test warning devices, horn, lights, and other safety equipment
and accessories.
2. With the key switch ON, check the diagnostic display. The diag-
nostic display should show the charge remaining on the battery,
the hour meter or a fault code. If the fault code is not an operator
fault code, notify a service technician.
3. Be sure all controls and systems operate freely and return to
neutral properly. Check the:
• Brake system
• Hydraulic controls
• Control handle (Direction/Accelerator and Steering control)
• Steering system
When the functional checks are completed:
1. Bring truck to complete stop.
2. Lower the lift mechanism fully.
3. Raise handle to the full "up" position (Brake will automatically
apply when the handle is raised).
4. Turn the ignition switch to the OFF position.
If you are going to leave the truck unattended:
5. Remove the key.
6. Block the wheels, if the truck has the possibility of moving.
7. Unplug the battery.