44
45
Operating Precautions
To prevent injury, risk of burns, fire, and electric shock the following
precautions should be observed:
• Prior to use, please read the enclosed operating instructions thor-
oughly to prevent injury due to improper usage.
• Do not operate this unit if the insulation on the AC power cord or
timer controller cord is damaged or torn.
• Do not use this unit if you have had a recent injury or major sur-
gery. Please consult your physician first.
• Use by children should be supervised.
• Should this unit need to be cleaned, wipe with a soft damp cloth.
• When using the Exerciser Elite® on light colored carpet, place a
towel completely under the machine to prevent rubber marks on
the carpet.
Appliance Precautions
• Unplug unit when unattended for an extended period
of time.
• Do not use in or around water due to danger of
electrical shock.
• Keep cords away from heated surface.
• Never insert any object into any opening on the unit.
• Unit must be repaired by warrantor listed on warranty card.
• Do not attempt to disassemble the unit for repair.
Any unauthorized repairs of your unit will void the
manufacturer warranty.
• Do not operate in vicinity of aerosol products,
flammable gases or when oxygen is being administered
(oxygen tent).
• Avoid using the unit (or storing it) in a location such
as the bathroom, where excessive moisture, heat or humidity may
be present.
• The Exerciser Elite® does not interfere with pacemakers,
defibrillators, automatic insulin pumps or automatic drug pumps.
For further warranty information, refer to the warranty card packaged with
each unit.
Problem
Solution
Machine will not
change speeds.
Note: Voltage fluc-
tuations may cause the
machine to lock onto
one speed. This is indi-
cated when the machine
will run the same speed
regardless of the selected
speed.
Turn the machine off and unplug the AC
power cord from the electrical outlet. Wait
5 seconds and plug the AC power cord back
into the electrical outlet. Push the power but-
ton to turn the machine on and then set the
desired time and speed. If this does not cor-
rect the problem, contact customer support
for further information.
Machine is speeding
up even though I did
not select a different
speed.
When you first turn on the machine, if it
reads P1 or P2 on the digital timer display
this indicates you have pushed the Prog but-
ton instead of the power button. To reset the
machine, push the power button to turn the
unit off. Press the power button again to turn
the unit on. This time the display should
show the number 2. Now you can select your
desired time and speed. If this does not cor-
rect the problem, contact customer support
for further information.
The machine only
runs for 2 or 3 sec-
onds and shuts off.
This indicates a problem with the speed sen-
sor circuit board. Unplug the AC power cord
from the electrical outlet, wait 5 seconds
and plug the AC power cord back into the
electrical outlet. If this does not correct the
problem, contact customer support for fur-
ther information.
Troubleshooting Guide
This guide provides helpful solutions to issues you may encounter while
using the Exerciser Elite®. If you still cannot find the solution to your prob-
lem in this guide, please contact customer support for further information.
