VMA643
13
English
Installation and W
ire
connection Manual
Installing the Monitor Stand/Display Unit
5. Temporarily remove the display unit.
Lift up the display unit while pressing down
on the unlock knob to temporarily remove
the display unit.
6. Attach the stand base to the determined
location on the attachment surface.
Remove the peel-off sheet from the base of
the stand base, and firmly attach the stand
base to the determined location (e.g. glove
compartment).
Notes:
• Before attaching the stand base, be sure to
wipe the attachment surface clean.
• After attaching the stand base, press down
hard so that the stand base is firmly attached
to the attachment surface.
While pressing down
Lift up.
7. After attaching the stand base, fasten in
place with screws.
Fasten the stand base using the self-tapping
screws (provided).
Note:
• Sometimes strong adhesion between the
stand base and the attachment surface
cannot be obtained by the double-sided
adhesive tape alone depending on the
material of the attachment surface or heat.
For extra safety, firmly fasten the stand base
in place using the self-tapping screws. (In this
case, note that screw holes will be drilled into
the attachment surface.)
8. After about 24 hours, install the display unit
and adjust its angle for ease of viewing.
Front/back, left/right:
Loosen the angle adjustment screw to
adjust the angle.
Top/bottom:
Temporarily remove the display unit from
the monitor stand, and loosen the screw
with the Allen key (provided) and adjust
the position of the guide holder.
Self-tapping screws
(provided)
Loose the angle
adjustment
screw, and
adjust the front/
back and left/
right angles.
