Clarion RDX455D, Owner'S Manual

Page: 7 / 16

9
English
Basic Operations
When this unit is turned on, starting and stop-
ping the engine of a car with its volume raised
to the maximum level may harm your hearing.
Be careful about adjusting the volume.
Turning ON the Power and Adjusting
the Volume
1) Press the POWER button .
*
To turn off the power, press the POWER button
for 1 second or longer.
2) Press the FNC button and select another
operation mode. Every time the FNC button
is pressed, the display changes the oper-
ation mode as:
Radio
➜
CD
➜
CD changer
➜
MD changer
➜
Radio
Notes:
• The operation mode not connected to the unit will not
be selected.
•
If the CD mode is selected when no disc is inserted,
the display flashes “
DISC ” and the mode will be
switched to the radio mode instead.
3) Adjust the volume by pressing the Up/Down
button .
: Sets the volume up.
: Sets the volume down.
Audio Mode Adjustments
1) Press the A-M button and select the mode
you want to adjust. Every time the A-M button
is pressed, the display changes as:
BASS/TRE
➜
BAL/FAD
➜
originally selected
mode
2) After selecting a mode, adjust the mode by
using either the Left/Right button , or the
Up/Down button .
<Bass adjustment>
: Increases the bass.
: Decreases the bass.
<Treble adjustment>
: Increases the treble.
: Decreases the treble.
<Balance adjustment>
: The volume of the right speakers are
increased.
: The volume of the left speakers are
increased.
<Fader adjustment>
: The volume of the front speakers are
increased.
: The volume of the rear speakers are
increased.
Setting the Z-enhancer
This unit comes with three types of sound tone
effects stored in memory. Select the one you prefer.
*
The factory default setting is “Z-EHCR OFF”.
Each time you press Z-EHCR button , the
tone effect changes in the following order.
“Z-ENHANCER 1”
➜
“Z-ENHANCER 2”
➜
“Z-ENHANCER 3”
➜
“Z-EHCR OFF”
➜
“Z-ENHANCER 1”...
• Z-ENHANCER 1: bass emphasized
• Z-ENHANCER 2: treble emphasized
• Z-ENHANCER 3: bass and treble emphasized
• Z-EHCR OFF: no sound effect
Loudness Effect
In order to turn on/off the loudness effect, use
the LD button
for 2 seconds or longer. Every
time the LD button is pressed and held for 2
seconds or longer, the loudness effect switches
on and off.
*
When the loudness effect is on, the display will show
“LOUD.”
Switching the Clock Display
While pressing the BND button , every time
the DISP button is pressed, the display will
change between the operation mode and the
clock display.
Setting the Clock
1) While pressing the BND button , press the
DISP button to display the clock
display.
2) While pressing the BND button , press and
hold the DISP button for 2 seconds or
longer.
3) Press the Left button , then set the current
hour.
18
12
16
12
16
12
16
17
17
8
2
18
17
17
2
3
3
3
3
8. OPERATION
CAUTION