Clarion OHM106, Owner'S Manual

Page: 14 / 36

14 OHM106/156
English
Tools and additional components
You will need:
•
A Phillips-head screwdriver when mounting the unit in the vehicle
•
4-6 screws to attach the ceiling bracket to the ceiling of the vehicle (not included)
•
High-quality RCA input-output cables
Extra cable can cause signal loss and act as an antenna for noise. Use only high-
quality RCA cables that are no longer than necessary to make a direct connection
with the source unit(s) and monitor.
Before you begin
1.
Verify that the vehicle electrical components function, including: power windows,
power door locks, air conditioning, lights, etc.
2. Test fit the location of the overhead monitor system to ensure it will not interfere with
the operation of the vehicle.
3. If applicable, verify that the monitor, when mounted, will not interfere with the
operation of the sun roof.
4. Determine the location of the audio/video source(s).
5. Disconnect the negative battery terminal before making any wiring connections.
CAUTION
Do not open the case. There are no serviceable parts inside. If
you drop anything into the unit during installation, consult with
your Clarion Dealer or an authorized Clarion service center.
Mounting and wiring precautions
The OHM106/156 should be mounted in the ceiling of the vehicle. The front panel
controls should be easily accessible from the rear seat. In addition:
•
This unit is exclusively for vehicles with a negative ground, 12V power supply.
•
This unit requires additional mobile audio components, such as a DVD player, for
proper operation.
•
Always use great care when attaching anything to a vehicle! Check clearances on
both sides of the planned installation before drilling any holes or installing any
screws.
OHM.pmd 2006-02-28, 13:00 14