DOC ID - 1990
• Rev 01 (
47-00014 Rev A)
3 / 7
•
Trip the translator tamper to enroll the translator into the panel.
- or -
•
Enter ID into panel. The Translator’s ID is printed on the bar code label.
B. Access the ClareOne panel
’s Sensor Settings, then select the type of sensor to add. Trip one of the repeated or
translated sensors to enroll it with the panel.
C. Repeat step B for each repeated or translated sensor.
4. Finish
A. With the translator cover open, perform a panel sensor test.
B. Close the cover. Test and verify proper operation of the sensors at the panel.
C. Cut the lock wire to lock the translator (for more information on locking, refer to the Advanced Setup section
below).
CAUTION:
Cutting the lock wire prevents the removal of sensors from the W2WL.
D. Secure cover with screw.
Panel Diagram
Advanced Setup
1. Mount and Wire
A. Select a mounting location and position.
•
When configured as a repeater, the W2WL should be
placed between the sensors to which it is paired and
the ClareOne panel.
•
When configured as a translator, the W2WL should
be located in a centralized location to the sensors that
are paired to it. The W2WL must be at least 5 feet
away from the ClareOne panel to allow for proper
wireless communication. Do NOT mount the W2WL in
a metal can or on a metal surface.
