CLAGE
29
EN
7. Electrical connection
Note: If necessary, the connecting terminal can be displaced to the upper part
of the appliance. If you want to do so, please follow the instructions in the next
chapter.
Check that the power supply is switched off prior to electrical connection!
1. Dismantle approximately 6 cm off the connecting cable above the wall outlet. With
the smaller opening ahead, slide the water splash protection sleeve over the con-
necting cable so that the sleeve is flush with the wall. This prevents any leaking
water from coming into contact with the electrical leads. It must not become dam-
aged! The protection sleeve must be used!
2. Open the control panel rightwards.
3. Strip the cables and plug them in the connecting terminals according to the wiring
diagram. The appliance must be earthed.
4. Pull the protective sleeve over the connecting cables until the sleeve fits perfectly in
the recess of the intermediate panel. Adjust the water splash protection sleeve as
illustrated. Reinsert the control panel and lock it on the heating element.
5. Place the hood on the appliance and screw in the fastening screw. After that you
can reinsert the faceplate.
Electrical connection from below
Check that the power supply is switched off prior to electrical connection!
1. Open the prepared breaking point (S) in the upper part of the appliance by pressing
with a blunt implement (e.g. srewdriver).
2. Slit the grommet to match the cable size. The opening in the grommet should be
slightly smaller than the cross-section of the cable in order to ensure optimum pro-
tection against water. Fit the grommet into the opening. The protection grommet
must be used!
3. Dismantle the cable roughly 6 cm above the point where it emerges from the wall.
Hold the prepared appliance so that you can route the cable into the grommet with
the other hand.
4. Place the appliance on the heater bracket so that the threaded rod of the wall brack-
et fits in the provided hole of the appliance.
5. Open the control panel rightwards.
6. Unscrew the fastening screw of the connecting terminal. Displace the connecting
terminal to the upper foot. Affix the connecting terminal again.
7. Strip the cables and plug them in the connecting terminals according to the wiring
diagram. The appliance must be earthed.
8. Reinsert the control panel and lock it on the heating element.
9. Place the hood on the appliance and screw in the fastening screw. After that you
can reinsert the faceplate.
Electrical connection from above
