Tempo Hybrid
Tempo Hybrid
Page 9
DELETE A PROGRAMME. (1) To delete a programme, simply set the start time to OFF (watering NOT active).
RESET. (2) To reset the settings, press the indicated keys for at least 10 seconds.
(3) the message SET will appear, then 24h and finally all the symbols will activate. At this point the two keys can
be released and the reset has been carried out. Then reset: the clock time (hours and minutes), the date,
programming watering.
Tempo Hybrid (cod.): 8487
USE WITH RAIN SENSOR. It is possible to connect the water timer to a wire rain sensor (Rain Sensor code 90915)
or a radio-frequency rain sensor (Rain Sensor RF code 90831 + Rain Sensor RF interface code 8480).
The sensor informs the water timer when the rain water which has collected inside the sensor exceeds 5 mm
(rain status) and when this water has evaporated (normal operating status). The water timer automatically
suspends watering activities while it is raining and signals sensor intervention on the display.
The Rain Sensor must be connected to the designated electrical contacts on the inner side of the programming
module after the jumper has been removed from the contacts(1).
(2)RAIN SENSOR RF: install the Rain Sensor RF interface by inserting the wire aerial into the designated rings.
(3)WIRE RAIN SENSOR: connect the sensor connector. Make sure that the bipolar cable enters through the
cable passage in the lower part of the water timer.
NOTA: If the Rain Sensor is not used, the jumper must remain installed on the contacts.
Tempo Hybrid (cod.): 8487
cod. 90831
cod. 8480
cod. 90915
OK!!!
User manual
User manual
1
1
2
2
3
3
1
1
2
2
3
3
