Claas LEXION 480, Repair Manual

Page: 227 / 1018

188 678.1 - RHB LEXION 480
3.6.13
Axial rotors
Suspend the rotor at the centre and lift it out of the
machine.
(Fig. 41)
Installing the axial rotor
1. Suspend the axial rotor at the centre and lift it into
the machine up to the middle.
2. Relocate the lifting strap and place the front of the
axial rotor on the separating grate. Push the rotor
into the machine up to the supporting arm.
(Fig. 42)
3. Unscrew one countersunk head bolt M 10 x 30
from the wear edge. Bolt down the lifting strap
safely with a M 10 x 60 bolt. Now lift the axial rotor
upwards through the grain tank opening.
(Fig. 43)
4. Lift the axial rotor with the ball journals into the
supporting arm. Bolt down the cover with two
hex. bolts and remove the lifting strap.
5. Bolt down end plate (A) and sensor plate (S).
(Fig. 34)
6.
Installing the axial rotor gearbox
, see
page 7.15.20
7. Adjust the wear edge of the axial rotor so that the
clearance to the supporting arm is 0.5
+1
mm .
8. Grease axial rotor.
41
42
43