Claas LEXION 410, Operator'S Manual

Page: 29 / 41

298 425.0 - BA LEXION 460 - 410
4.1.3
Safety rules
7. Before mounting or entering the grain tank,
make sure that the drive is disengaged and that
the engine has been stopped. Ensure that no
other person can restart the engine.
8. When carrying a cutterbar along during travel
on public roads and lanes, the finger bar and/or
the crop lifters must be covered.
Compressor-type air conditioner
1. The air conditioning system is filled with HFC
refrigerant R 134A. HFC refrigerants must not
be vented to the atmosphere. – Therefore,
please take appropriate precautions when
working on the compressor-type air conditioner.
2. Maintenance and repairs are only to be carried
out by authorized service centres qualified to
handle refrigerants. Refrigerants must always
be discharged by use of the correct recovery
equipment and disposed of for recycling.
Service
1. Repair, service and cleaning work and the
elimination of malfunctions should only be per-
formed with the drive and engine switched off.
Remove the main switch key (ignition key)!
2. Escaping fluid (fuel or hydraulic oil) under high
pressure can penetrate the skin and cause
serious injury. If any fluid is injected into the
skin, consult a doctor immediately as otherwise
serious infections may result!
3. Be careful when opening the radiator filler cap.
As long as the engine is hot, the radiator is
under pressure.
4. Dispose of oil, fuel and filters in a way that is
harmless to the environment and in accordance
with existing anti-pollution regulations.
5. Do not attempt to mount a tyre unless you
have the proper equipment and experience to
perform the job safely.
6. Retighten the wheel nuts and wheel bolts
regularly.
7. Only have qualified workshops carry out repair
work on the hydraulic system.
Basic rule
Always check the operating and road safety of the
combine before starting the machine.
Noise level
The noise level at the ear of the driver in the cabin
with doors and windows closed is 82 db (A).
Hydraulic accumulators
Take particular care when working on hydraulic
accumulators! Hydraulic accumulators are under
high pressure!
In the case of valve-controlled accumulators such
as e.g. for the Autopilot, the short-circuit screw has
to be loosened before starting repair work on the
accumulator so that the hydraulic pressure is
relieved.