CK4L-3000B instruction
Shenzhen Createk Electronics
·
www.ckdz.com
·
Tel: +86-755-26643017
·
Fax:
+86-755-26644342
Address
：
Floor 2/3,8 Block,A Area,Tanglang Industry Zone,Xili Town,Nanshan District , 518055, Shenzhen City
Connector: Owen Zhong, E-mail:
, Mobile: +86 13714452125 Page 13 of 26
ITEM 6: under item #6 (output resolution), press
“←”
or
“→”
to choose one of the output
format above, and then press “Enter” to save the setting. For example, as select “1024*768_60”,
the resolution is: 1024*768 and frequency is 60Hz. However, LED screen pixel lattice is not
1024*768. When the pixel lattice is lower than 1024*768, we could adjust the output resolution
closer to LED pixel lattice to achieve an optimal image, as the following demonstration:
Picture 4
In picture 4, the size and location of output image is defined by 4 parameters and they are
shown in below table (In CK4L-3000B effective on the main window)
Item number
Name
Parameter
2
Output horizontal begins
Hor_Str
3
Output width
Hor_Width
4
Output vertical begins
Vert_Str
5
Output height
Vert-Height
ITEM2: “
Output horizontal begins
”: set the horizontal starting point of output picture
ITEM3: “
Output width
”: set the output width of output picture
ITEM4: “
Output vertical begins
”: set the
vertical
starting point of output picture
ITEM5: “
Output height
”: set the output height of output picture
The initial coordinate (0
，
0) is defined on the top left corner. According to the size of LED screen
