RRC
GRC
RV3*
NHS
HR
LN
FH100
HAP
BSA2
LHA
LHAG
HKP
HEP
HCP
HMF
HMFB
HFP
HLC
HGP
FH500
HBL
HDL
HMD
HJL
BHE
CKG
CK
CKA
CKS
CKF
CKJ
CKL2
CKH2
CKLB2
FJ
FK
Ending
BHA/
BHG
HLA/
HLB
HLAG/
HLBG
CKL2
-*-HC
NCK/
SCK/FCK
Cylinder/hand with length measuring sensor
Length measuring function
217
Use appropriate pliers (C type snap ring installation
tool) to install and remove the rod bushing.
Even when appropriate pliers are used, the snap ring
may come off, causing possible damage or injury.
When installing, check that the snap ring fits into the
groove before supplying air.
CAUTION
1. Cylinder
During Use & Maintenance
Regularly apply grease to the oscillating section of
the master key to extend device life.
Do not apply excessive force caused by dropping or
collision to the master jaw, small jaw, or bearing
guide. This could cause a large play in the master
jaw and decrease the hand’s repeatability to drop.
The stop position of the piston, which acts as the
sensor detector, could vary and decrease repeat-
ability.
CAUTION
2. Hand
LN
Series
