AX
Series
9
ABSODEX selection guide specifications check sheet
Table direct drive
(Note) Contact CKD for chain drives and gear drives.
■ Operating conditions
1. Index 2. Oscillator
Movement angle Ψ (°)
or no. of indexes
Movement time t1 (sec.)
Cycle time
t0 (sec.)
cycle time=moving time+dwelling time
(Note) Index time is movement time + settling time.
The settling time differs according to the working condition, but generally is between 0.025 and 0.2s.
Your company name
Division
TEL
Your name
FAX
■ Load conditions
Table
Material
1. Steel 2. Aluminum
Outline
Dt(mm)
Plate thickness ht(mm)
Weight
m1(kg)
Workpiece
Quantity nw (pc.)
Max. weight mw (kg/pc.)
Installation center Dp(mm)
Pallet fixture
Quantity np (pc.)
Max. weight mp (kg/pc.)
■ Others
Installation attitude
1. Horizontal (Fig.2) 2.Vertical (Fig. 3)
Extemal job
1. None
2. available
(Note) Eccentric load caused by gravity from vertical
installation, extemal load caused by caulking work.
Dial plate support form bottom
1. None
2. available
Coefficient of friction
μ
Work radius
Rf(mm)
Device rigidity
1. High
2. Low (Note)
(Note) When using a spline, when unit cannot be fixed
directly onto the device (Fig. 4), when there is
a mechanism such as a chuck on the table.
Extension with table shaft
1. None
2. available (Fig. 5)
Actuator movement
1. None
2. available
(Note) When actuator is mounted on X-Y table or vertical
mechanism, etc., and mounted actuator moves.
(Note) If 2 is selected for any item, contact CKD.
(Fig. 4) Installation rigidity: Low
(Note) Attach system outline and reference drawings so that the
optimal model can be selected.
(Fig. 1) Load conditions
(Fig. 2) Installation orientation: Horizontal
(Fig. 3) Installation orientation: Vertical
(Fig. 5) Extension with shaft
Dp
Rf
μ
Dt
ht
Pallet fixture
■ Use conditions, environmental conditions (Optional)
Actuator ambient temperature (°C)
Motor cable length (m)
Driver ambient temperature (°C)
DC24V power supply cable length (m)
DC24V power supply coil diameter (mm
2
)
DC24V power supply voltage accuracy (%)
DC24V line point of contact quantity (pc.)
DC24V line point of contact resistance (MΩ / pc.)
* You can do a more rigorous selection by filling in this field.
* With a power supply cable 1.25mm² or more, please use one as short (recommended length 1m or less) as possible.
* If the output voltage is low in a power supply with voltage adjustment, please adjust it to 24V and use it.
Workpiece
Selection guide
