8. Set the DMX Starting Address DIP Switch to the desired starting address, referring to the DMX
DIP Switch Tables in the manual.
Note that the DMX Address DIP switches read left to right,
while the binary table below reads right to left
Start Address
DIP Setting
987654321
1 000000001
Turn power off before connecting your loads
Connecting 12V Three Color RGB Tape
12 Volt three color LED tape is provided
with a 12VDC circuit and a –VDC
circuit for each color.
ire.
9. Connect the +12VDC circuit to any
one of the four + output terminals.
The + terminals are bussed, and
provide constant voltage. Note that
some tape comes pre-wired with
Black wire for the +12VDC circuit
while other tape comes pre-wire
with White w
10. Connect the R, G and B circuits
each to one the four – output terminals (in the case of four color tape, connect the A or W
circuit to the fourth – output terminal). The
– terminals are the PWM dimmed outputs of the D4 Dimmer. Note that some tape comes with
the R, G and B (and A or W) circuits in a different order than others.
11. Select the LED Curve for each dimmer channel used.
12. Power up your Dimmer and test your load connections with the bump buttons
13. If you wish to change the PWM frequency, use RDM or the MOD switch to select the frequency
desired.
Connecting Single Color Tape
12 Volt single color tape is provided with a VDC circuit and a –VDC circuit.
1. Connect the +VDC circuit to one of the + output terminals and connect the -VDC circuit to the
accompanying –output terminal. Up to two runs of single color tape can be driven and dimmed
by a D2 Dimmer.
2. Select the LED Curve for each dimmer channel used.
3. If you wish to change the PWM frequency, use RDM or the MOD switch to select the frequency
desired.
page 2 of 3
