Citrix NetScaler EE, Installation And Configuration Manual

Page: 545 / 1026

© 1999-2017 Citrix Systems, Inc. All rights reserved. p.545 https://docs.citrix.com
WCCP Clustering
Sep 12, 2014
The WCCP clustering feature enables you to multiply your acceleration capacity by assigning more than one SD-WAN
appliance to the same links. You can cluster up to 32 identical appliances, for up to 32 times the capacity. Because it uses
the WCCP 2.0 standard, WCCP clustering works on most routers and some smart switches, most likely including those you
are already using.
Because it uses a decentralized protocol, WCCP clustering allows SD-WAN appliances to be added or removed at will. If an
appliance fails, its traffic is rerouted to the surviving appliances.
Unlike SD-WAN high-availability, an active/passive pair that uses two appliances to provide the performance of a single
appliance, the same appliances deployed as a WCCP cluster has twice the performance of a single appliance, delivering both
redundancy and improved performance.
In addition to adding more appliances as your site’s needs increase, you can use Citrix’s “Pay as You Grow” feature to
increase your appliances’ capabilities through license upgrades.
Citrix Command Center is recommended for managing WCCP clusters. The following figure shows a basic network of a
cluster of SD-WAN appliances in WCCP mode, administered by using Citrix Command Center.
Figure 1. SD-WAN Cluster Administered by Using Citrix Command Center
The WCCP protocol supports up to 32 appliances in a fault-tolerant, load balanced array called a cluster. In the example
below, three identical appliances (same model, same software version) are cabled identically and configured identically
except for their IP addresses. Appliances using the same service groups with the same router can become a load balanced
WCCP cluster. When a new appliance registers itself with the router, it can join the existing pool of appliances and receive
its share of traffic. If an appliance leaves the network (as indicated by the absence of heartbeat signals), the cluster is
rebalanced so that only the remaining appliances are used.
Figure 2. A load-balanced WCCP cluster with three appliances
One appliance in the cluster is selected as the designated cache, and controls the load-balancing behavior of the appliances
in the cluster. The designated cache is the appliance with the lowest IP address. Because the appliances have identical
configurations, it doesn’t matter which one is the designated cache. If the current designated cache goes offline, a
different appliance becomes the designated cache.
The designated cache determines how the load-balanced traffic is allocated and informs the router of these decisions. The
router shares information with all members of the cluster, so the cluster can operate even if the designated cache goes
offline.
Note: As normally configured, a SD-WAN WANOP 4000/5000 appliance appears as two WCCP caches to the router.
Load-Balancing Algorit hm
Load-Balancing Algorit hm
Load balancing in WCCP is static, except when an appliance enters or leaves the cluster, which causes the cluster to be
rebalanced among its current members.