Citrix NetScaler EE, Installation And Configuration Manual

Page: 47 / 1026

© 1999-2017 Citrix Systems, Inc. All rights reserved. p.47 https://docs.citrix.com
- Memory Memory: 4GB RAM
- Virt ual Dat ast ore Virt ual Dat ast ore: 40 GB disk
- Management Int erf ace Management Int erf ace: 1 (default)
SD-WAN VPX-SE interface specifications are as follows:
- SD-WAN VPX-SE supports a maximum number of five interfaces.
- The first interface is reserved for use as the Management IP Address for the Virtual Appliance.
- Before powering up the new VM for the SD-WAN VPX-SE Virtual Appliance, you must configure and assign
additional interfaces (one each) for the LAN and WAN.
- For VPX-SE, bridges are not created by default for the data interface (for example, eth1 and eth2).
If you are not using DHCP, you must configure a static Management IP Address for the SD-WAN VPX-SE Virtual
Appliance.
Note
DHCP is enabled by default for the SD-WAN VPX-SE Management IP Address.
To configure a static Management IP Address for a SD-WAN VPX-SE Virtual Appliance, do the following:
1. Open the vSphere Client or XenServer Client where you created the SD-WAN VPX-SE Virtual Machine (VM).
2. Open the vSphere or XenServer Console for the new SD-WAN VPX-SE, and log into the Administrator account for the
VM.
- Default Administrator user name: admin admin
- Default Administrator password: password password
3. Enter the following command lines at the console CLI prompt:
management _ip management _ip
set _management _ip set int erf ace <ip> <subnet mask> <gat eway> set _management _ip set int erf ace <ip> <subnet mask> <gat eway>
Where:
<ip> is the Management IP Address for the SD-WAN VPX-SE Virtual Appliance.
<subnetmask>
is the subnet mask used to define the network in which the
SD-WAN VPX-SE Virtual Appliance resides.
<gateway> is the Gateway IP Address of the SD-WAN VPX-SE Virtual Appliance will use to communicate with
external networks.
4. Restart the SD-WAN VPX-SE Virtual Appliance VM.