Citrix ByteMobile T1010, Installation, Configuration And Administration

Page: 59 / 172

T-Series Traffic Director Installation, Configuration and Administration Guide 2-19
Connecting and Disconnecting AC Power
VT100 terminal emulation, 9600 baud, 8 data bits, 1 stop bit, parity, and flow control set to
NONE. Then connect one end of the console cable to the RS232 serial port on the T1000
and the other end to the computer or terminal.
Step 1 Insert the DB-9 connector at the end of the cable into the console port that is located on the
front panel of the T1000 as shown in Figure 2-7.
Step 2 To use a cable with an RJ-45 converter, insert the optional converter provided into the
console port and attach the cable to it.
Step 3 Insert the RJ-45 connector at the other end of the cable into the serial port of the computer or
terminal.
Connecting the LOM Port
The T1000 includes a lights-out management (LOM) port that is used for support purposes.
Step 1 Insert the RJ-45 connector on one end of your Ethernet cable into one of the LOM port on
the front panel of the T1000, as shown in Figure 2-7.
Step 2 Insert the RJ-45 connector on the other end into the target device, such as a router or switch.
Step 3 By design, the LOM port does not have LEDs to verify connectivity. You must verify the
connection using a terminal device. See
“Accessing and Configuring the LOM Port” on
page 2-31.
Connecting and Disconnecting AC Power
This section describes how to connect and disconnect power to a T1000 configured with AC
power. This section has the following topics:
• “Before you Begin AC Power Connection” on page 2-19
• “Connecting an AC Shelf to Power” on page 2-21
• “Turning On AC Power to the System” on page 2-22
• “Turning Off AC Power to the System” on page 2-22
For procedures related to DC power, see “Connecting and Disconnecting DC Power” on
page 2-22.
Note: The T1000 includes two power supplies, but functions properly with a single
power supply. Bytemobile recommends connecting both power supplies (to
independent power sources) for redundancy.
Before you Begin AC Power Connection
Before you begin the power connection/disconnection procedures, note the following:
• Review the safety warnings at the beginning of this document, and below.