Log on to the NetScaler with the following credentials:
User name:
nsroot
Password:
nsroot
To configure the NetScaler by using the NetScaler
command line
At the NetScaler command prompt, type:
w
set ns config -ipaddress<IPAddress> -netmask<subnetMask>
w
add ns ip<IPAddress> <subnetMask> -type<type>
w
add route Network<subnetMask> <gateway>
w
set system user<userName> <password>
w
save ns config
w
reboot
Example
set ns config -ipaddress 10.102.29.60 -netmask
255.255.255.0 add ns ip 10.102.29.61 255.255.255.0 -
type snip add route 0.0.0.0 0.0.0.0 10.102.29.1 set
system user nsroot administrator save ns config
reboot
Note:
For information about deploying a high availability (HA) pair, see the
Citrix
NetScaler Networking Guide
at
http://support.citrix.com/article/CTX132369
.
LCD Keypad Setup
To set up the appliance by using the LCD keypad on the front panel of the appliance,
enter the following initial settings in the following order:
1. subnet mask
2. NSIP
3. gateway
The NSIP and the default gateway should be on the same subnet.
The subnet mask, NSIP, and gateway values are saved in the configuration file. You can
then use the NSIP to connect to the appliance remotely. For more information, see the
Citrix NetScaler Hardware Installation and Setup Guide at
http://support.citrix.com/
article/CTX132365
.
Note:
For information about deploying a high availability (HA) pair, see the
Citrix
NetScaler Networking Guide
at
http://support.citrix.com/article/CTX132369
.
Citrix
®
NetScaler
®
10 Quick Start Guide: MPX 17550/19550/20550/21550 Platform
9
