Citizen PPU-700, Command Reference Manual

Page: 33 / 188

- 31 -
GS ! n
[Function] Specifying the character size
[Code]
<
1D
>
H
<
21
>
H
<
n
>
[Range] 0
≦ｎ≦
255 where: 1
≦
vertical magnification
≦
8
、
1
≦
horizontal magnification
≦
8
[Outline] Specifies the character size (Vertical and horizontal magnification).
Value
Bit Function
Hex. Number Decimal Number
0
1
2
3
Vertical magnification
specification
Refer to Table 2,
“Vertical Magnification”.
4
5
6
7
Horizontal magnification
specification
Refer to Table 1,
“Horizontal Magnification”.
Table 1 Horizontal Magnification Table 2 Vertical Magnification
Hex. Decimal Magnification Hex. Decimal Magnification
00 0 1×
（
Standard
）
00 0 1×
（
Standard
）
10 16 2×
（
Double width
）
01 1 2×
（
Double
）
20 32 3× 02 2 3×
30 48 4× 03 3 4×
40 64 5× 04 4 5×
50 80 6× 05 5 6×
60 96 7× 06 6 7×
70 112 8× 07 7 8×
[Caution] • This command is valid for all characters (alphanumeric, kana, and kanji) except for
HRI characters.
• This command is ignored if either the vertical magnification or horizontal magnification
is out of the defined range.
• In STANDARD MODE, the vertical direction is defined as the paper feed direction, and
the horizontal direction is defined as the direction perpendicular to the paper feed.
• Setting memory SW 3-7 to ON allows the horizontal and vertical relations to be
interchanged when 90°-right-turnning of character is specified.
• In PAGE MODE, the vertical direction means the top-bottom direction of each
character. The horizontal direction means the side-to-side direction of each character.
• If characters of different vertical magnification are contained in a line, the baseline of
each character is lined up.
• Horizontal and vertical magnification can also be specified/canceled by ESC ! but the
setting of command last processed is valid.
[Default]
ｎ＝
0
[See Also] ESC !