Cistermiser EasyflushEVO, Manual

Page: 14 / 24

14 | cistermiser.co.uk Have a question? Call our customer support team on 0118 969 1611
Wave/walkaway mode switching (this will restore default settings)
Sensor will flash single
central green LED
for wave mode
The sensor will flash one central
green LED to indicate wave function,
to change function put your hand in
front of the sensor for 3 second.
A B
C
or double top/bottom green
LEDs for walkaway mode
11. Advanced settings guide
Carry out only if settings need to be changed.
1
Disconnect power, wait for 5 seconds and reconnect.
If a hand is not placed over the sensor, it will go into normal operation mode.
You are now in configuration mode
2
3
Move your hand to the distance from the sensor you would like
to set as maximum range. Wait 8 seconds until constant triple
green LEDs show.
Sensor distance
is now set.
B
C
Stand at the distance from the sensor you would
like to set as maximum range. Wait 8 seconds
until constant triple green LEDs show.
Sensor distance
is now set.
C
B
X 1
Wait for 1 x triple
red LEDs to enter
wave/ walkaway
setting
A
Wait for 2 x triple
red LEDs to enter
sensing range
mode
X 2
A
Wait for 2 x triple
red LEDs to enter
sensing range
mode
X 2
Wave sensing range adjustment
(when Wave variant is selected)
Walkaway sensing range adjustment
(when Walkaway variant is selected)
When flashing triple
amber
.
Place hand 4-6cm from sensor until
constant triple green LEDs, then
remove hand.
During the triple red flash briefly
place your hand in front of
the sensor.
Briefly place your hand in front of
the sensor until triple green LEDs
flash slowly. Range configuration
mode will then be ready.
Briefly place your hand in front of
the sensor until triple green LEDs
flash slowly. Range configuration
mode will then be ready.