Cissell MANCONS, Manual

Page: 13 / 29

Page 12
CISSELL STEAM-AIR FINISHER
INSTRUCTIONS FOR ADJUSTING HEIGHT
OF REVOLVING FORM
Should the revolving form “drag” on the base rather than turn freely, the form must be
raised.
Conversely, if the revolving form hides too high above the base, permitting steam to
escape from the space between the form and base, the form must be lowered.
WHEN ADJUSTMENT MUST BE MADE, REMOVE REVOLVING FORM BY SIM-
PLY LIFTING IT STRAIGHT UP OFF THE BASE.
PROBLEM: Revolving form “drags” on base.
TO CORRECT: Loosen F286 Bearing Lock Nut. Turn F287 Bearing Adjustment
Screw COUNTERCLOCKWISE
CHECK ADJUSTMENT: Replace revolving form on base. Rotate form. If
perfectly adjusted, form will rotate freely and snugly
on felt seal around top of base. If form is still too
low... or too high...repeat adjustment until it is correct.
PROBLEM: Revolving Form rides too high above base.
TO CORRECT: Loosen F286 Bearing Lock Nut. Turn F287 Bearing Adjustment
Screw CLOCKWISE.
CHECK ADJUSTMENT: Replace revolving form on base. Rotate form. If
perfectly adjusted, form will rotate freely and snugly
on felt seal around top of base. If form is still too
high... or too low... repeat adjustment until it is correct.