12
4
Start the wash-cycle by pressing the Start button (S) and releasing it immediately.
The door is sealed and the cycle-LED lights up.
During the first
2 minutes
after starting, the program number is blinking and you
can change the program in case of a possibly wrong selection.
To do so, select another program with the SELECT button (P). This new program
will start immediately.
Start the machine
Display information
The
left display
will indicate
the temperature of the wash bath
- in °C or °F (on
machines where this function has been selected).
The
central display
shows
the remaining time
to the end of the wash cycle.
Indications of program
sequence
For programs which are being run for the first time, the machine will take a
theoretical time estimate. If this time indication does not correspond to the real
cycle time, the cycle time will be corrected from the second cycle onwards
(
Self-Teaching function of the machine
).
This correction will have to be preprogrammed and is
not activated on
program numbers higher than 20
. The corrected time will also be lost when
the power has been cut from the machine for more than 24 hours.
The
right display
will continue to show the
selected program number.
If a Level-stop was programmed (which halts the programmer during the filling
of the cylinder) and/or a Heat-stop (which stops the programmer during the
heating up of the wash bath, then the respective LED’s light up in the display.
Once the required water level and/or temperature have been reached, the LED
is turned off and the internal programmer advances again.
Wash cycle-LED’s
Each program segment has a corresponding LED. Each of these 6 LED’s light up
when the appropriate segment is executed. This way, the program sequence can
be accurately followed.
When a LED
blinks
, the machine is taking up water.
When a LED
blinks slowly
, the machine is heating up the water.
Spin-LED’s
When the water is drained at the at the end of a program segment and the machine
spins if so desired, the
left spin-LED
(intermediate spin) will light up together with
the cycle-LED.
- Functioning of the spin-LED’s during intermediate spin:
- Functioning of the spin-LED’s during gentle-intermediate spin:
LED
drain/distribution low spin
coast
Interm. spin blinking rapidly blinking slowly blinking slowly
LED
drain/distribution
low spin
coast
Interm
.
spin blinking rapidly continuously continuously
Summary of Contents for IPSO HF304
Page 1: ......
