Cissell HD50.1, Owner'S Manual

Page: 32 / 63

Page 32
INSTRUCTIONS FOR ALIGNING BASKET ON CISSELL DRYER
1. Loosen the 4 cast iron bearing bolts or gear reducer (1, 2, 3 & 4) on rear of dryer, and 2 adjusting bolts
#5, on gear reducer housing. (Fig. 3).
2. Place one “A” and two “B” diameter pins inside the drying compartment between the rim of the basket
opening and the rim of the door opening in the positions shown in Figure 1 and Figure 2. Check the two
“B” pins for equal clearance.
3. With the pins in position, tighten the two No. 5 bolts until flush against back of dryer. Retighten cast iron
bearing or gear reducer mounting bolts in the numerical order indicated in Figure 3. Tighten lock nuts No.
6 to secure bolts No. 5 in position. Then remove pins.
4. Check the space between basket and door opening at “A” pin and “B” pin positions (Figure 2). If the gap
is not approximately the same on both sides, repeat steps 1, 2 & 3.
NOTE: Use short sections of round steel rod for pins or drill bits may be used in place
of round rod.
Gear Reducer
Rear of Dryer
Fig. 3
Cast Iron Bearing