Page 4
Page 4
Page 4
Page 4
Page 4
INST
INST
INST
INST
INSTALLA
ALLA
ALLA
ALLA
ALLATION
TION
TION
TION
TION
Refer to illustration sheet
(1)
UNCRATE MACHINE. Check the nameplate voltage and current, making sure it
is the same
as the supply voltage and current.
(2)
SET MACHINE IN POSITION.
(3)
REMOVE THE REVOLVING FORM by holding the turning knob and the oppo-
site weight
“bucket” and lifting approximately 22”.
(4)
CONNECT STEAM SUPPLY LINE as shown on next page.
(5)
CONNECT RETURN LINE as shown on next page.
NOTE: Before final return line connection is made, open the steam supply valve
and blow all
foreign matter out of the steam lines and chamber. Failure
to do so will cause trap to
leak.
(6)
MAKE ELECTRICAL CONNECTIONS in 3” junction box on rear of the machine,
according
to applicable electric codes. Connections should include a fused
disconnect switch or circuit
breaker with “slo-blow” characteristics and be
capable of carrying 15 amps 115 volts or 8
amps 230 volts.
(7)
TURN ON ELECTRICAL POWER AND TEST THE MACHINE.
Replace the revolving assembly, remove the plastic protective bag, and open the
return and
steam lines.
