Cisco Unified 7905G, Administrator'S Manual

Page: 127 / 238

8-9
Cisco IP Phone Models 7905G and 7912G Administrator Guide (SIP)
OL-4277-01
Chapter 8 Profile and Web Page Parameters and Defaults
SIP Parameters
SIP Parameters
Table 8-2 describes the SIP parameters that you can configure through a phone’s
profile or through the SIP Parameters area on the phone’s web page
Tip
To access the SIP Parameters area directly from a web browser, enter
IP_address/SIPConfiguration, where IP_address is the IP address of your
Cisco IP Phone.
NPrintf IP address and port of a host PC to which phone debug messages are sent, in
the format IP_address.port (for example: 192.168.2.159.9000).
Note The host PC must be running the prserv.exe application at the
corresponding port. This application is available at Cisco.com.
To turn off debugging, set to 0 or to 0.0.0.0.0.
Value type: Extended IP address.
Default value: 0.0.0.0.0
For more information about using Nprintf and prserv.exe to collect information
for debugging, see the
“Debugging” section on page 9-5 .
TraceFlags Enables specific trace features when Nprintf is set to a valid host address and
port.
•
0=Disable debug messages.
• 1=Enable debug messages.
Value type: Bitmap.
Default value: 0x00000000
Table 8-1 Network Parameters (continued)
Parameter Description