Cisco TelePresence Server 7010, Hardware Installation And Maintenance Manual

Page: 266 / 287

B-8 Cisco 7010 Hardware Installation and Maintenance
Interface Processor LEDs
FSIP LEDs
The FSIP LEDs are shown in Figure B-10. As with the other interface processors, the enabled LED
goes on when the FSIP is enabled for operation. However, unlike the LED cluster on other interface
processors, the LEDs for each serial port are adjacent to the connector. Table B-2 lists descriptions
of each LED.
Figure B-10 FSIP LEDs
The conn (connected) LED goes on when the interface is connected to the network. During normal
operation, the three other LEDs go on to indicate data and timing signal traffic, or an idle pattern that
is commonly sent across the line during idle time.
Table B-2 FSIP LEDs
X X
X X
– – Both B and A off
Not connected
X X
X O
O O
Single attachment A on
plus both B and A on
Dual homed with A active; not a normal
condition; indicates potential problem on B
X X
O X
O O
Single attachment B on
plus both B and A on plus
Dual homed with B active, which is a
normal condition
X X
O X
O X
Single attachment B on
plus B on
Single attachment B, Dual homed A failed
X X
X O
X O
Single attachment A on
plus A on
Single attachment A, Dual homed B failed
1. For the LED patterns, “–” means off, “O” means on, and “X” means does not apply.
LED DTE Signal DCE Signal
RxC Receive clock (from DTE) (TxC) Transmit clock (to DTE)
RxD Receive data (from DTE) (TxD) Transmit data (from DTE)
TxC Send timing (from DCE) (RxC) Receive timing (to DTE)
LED Pattern
1
State Indication
ENABLED
H2062
-RxC -RxD -TxC -Conn